Electrician in Wagoner, OK

Same county, about 19 miles east

Hot Shot Electric Service Co. is a family-owned electrical contractor whose office is on the Wagoner County side of Broken Arrow. Wagoner, the county seat, is about 19 miles east of us. We have held Oklahoma electrical contractor license #26574 since 1995, and a licensed journeyman runs every job. If you need an electrician in Wagoner OK, call (918) 261-8024; someone on our team will answer and give you an honest window for the drive.

The first city in Indian Territory, and a lake town since 1950

Wagoner was incorporated on January 4, 1896, the first city incorporated in Indian Territory, and became the county seat at statehood. When Fort Gibson Lake was completed in 1950, the town grew into a place for weekend trips and retirement. That mix shapes the calls we get: older homes in town, and lake properties where a shop, a pump or outdoor lighting may sit a long way from the panel.

Outages are the big one out here

Outside the metro, storms and long outages are a bigger part of life, and a lot of our Wagoner work is about getting through them:

• Generator inlets and transfer switches. Run your portable generator on the circuits you choose without back-feeding the utility's lines. See generator transfer switches.
• Surge protection. Lightning and the surge when power comes back can take out HVAC boards, well pumps and electronics at once. A device at the panel protects the whole house. See whole-house surge protection.
• Partial power after an outage. If some rooms and your 240-volt appliances do not come back, you may have lost a leg of power on the utility side. Report it first; if the utility says its side is fine, we trace it. See troubleshooting and repair.

Permits and utilities

Inside Wagoner city limits, the City of Wagoner handles electrical permits and inspections. Properties outside the city, including many lake homes, fall under Wagoner County. When a job needs a permit, we pull it and schedule the inspection.

Power may come from PSO or an electric cooperative depending on where you are around Wagoner. Either way, the meter belongs to the utility and the meter base and everything inside belong to you, and we coordinate with the utility when storm damage needs repair before they reconnect.

Older homes in town

A town incorporated in 1896 has houses from every decade since. In Wagoner's older homes we tend to find the same handful of things: outlets with no ground, panels that ran out of spaces years ago, circuits that were extended one room at a time, and connections in attics and crawl spaces that were never put in a box. None of that automatically means a rewire. It means a licensed journeyman should look, tell you what is a hazard and what is just old, and price the part that matters.

Getting Wagoner work on the schedule

1. Call early in the day if you can. It makes same-day urgent work more likely on the longer drive.
2. Tell us what is happening and what you have already tried. We will ask about the panel and the age of the house.
3. You get a real arrival window. Planned work is set for a day that suits you.

Fans, lights and outdoor outlets

Covered porches and patios get a lot of use around the lake, and so do the outlets on them. We install damp-rated ceiling fans and patio lighting, add weatherproof GFCI outlets where you need them, and fix the ones that quit after a storm. See patio fans, lighting and heaters and landscape lighting.

When a breaker keeps tripping

A breaker that trips is protecting the wire behind it. The cause is usually too much load, a short, a ground fault or a breaker that has worn out. Resetting it over and over is not a fix, and replacing it without finding the cause rarely is either. A journeyman tracks down which one it is. See circuit breaker repair.

One more thing worth saying for a town this size: we do not treat a 19-mile drive as a reason to rush. The journeyman who comes to Wagoner does the same diagnosis, explains the same way and cleans up the same way he would two streets from our office.

If you are not sure whether a problem can wait for a scheduled day, call and describe it. We will tell you plainly whether to turn something off and wait, or whether it should be looked at today.

Cost and hours

Planned work gets a free estimate. Troubleshooting carries a diagnostic fee, which includes a roughly 20-point safety inspection, and you approve the price before any work starts. We work Monday to Friday, 8:00 AM to 4:30 PM, and return calls left outside those hours the next business morning. Request service online or call (918) 261-8024.