Electrician in Collinsville, OK

Electrician in Collinsville OK, with the drive planned in

Hot Shot Electric Service Co. is a family-owned electrical contractor from Broken Arrow, licensed in Oklahoma since 1995 under electrical contractor license #26574. Collinsville is about 24 miles north of our office, one of the farther cities we serve. That means the phone call matters: we ask what is going on, what you have tried and what the panel looks like, so the licensed journeyman arrives with what the job needs.

A small city that grew 40 percent

Collinsville incorporated in 1899 and, unusually, its residents voted in 1918 to move from Rogers County into Tulsa County so they would be closer to a county seat. Parts of the city are still in Rogers County today. More recently it has been growing fast: 5,606 people in 2010, 7,881 in 2020. That growth means two kinds of homes, and two kinds of calls.

Newer homes

Adding what the builder did not: a Level 2 EV charger, garage outlets for a freezer or a shop, a ceiling fan on the porch, outdoor GFCI outlets. And sometimes chasing nuisance tripping on AFCI and GFCI breakers.

Older homes near downtown

Outlets with no ground, panels that are full or aging, and circuits that were extended too many times. We repair what can be repaired and recommend a panel upgrade only when the panel is the problem.

Check these before you call

• The wall switch: many outlets are switch-controlled.
• The breaker: push a tripped one fully off, then on. If it trips again right away, stop.
• Every GFCI reset button you can find; one can control several rooms.
• Your utility's outage map, if more than one room is out.

If you smell burning, see scorching or hear buzzing, call (918) 261-8024 instead.

Permits and power

The City of Collinsville handles electrical permits and inspections inside city limits, and we pull the permit when a job needs one. Your electric provider depends on your address. The provider owns the lines and the meter; the meter base and the house wiring are yours. After storm damage to the service mast or meter base, we repair your side and coordinate the reconnect.

Garage and shop circuits

Bigger lots and newer garages around Collinsville mean a lot of requests for more power where people work on things. A freezer, a compressor, a welder or a set of shop lights can each want a circuit of its own. We run dedicated circuits from the panel when there is room, add a subpanel in the garage or shop when that makes more sense, and use GFCI protection where the code requires it. If the main panel is already near its limit, we tell you before you spend anything.

Why the breaker is not always the problem

When a breaker trips, it is tempting to replace it. Usually the breaker is fine and something on the circuit is wrong: too much load, a loose connection, a damaged cord, a failing appliance or moisture in an outdoor box. We find the cause first. See circuit breaker repair.

What the diagnostic visit includes

When something has stopped working, the visit carries a diagnostic fee. A licensed journeyman tests the circuits, connections and equipment involved, finds the actual cause, and explains it in plain English. The visit also includes a roughly 20-point safety inspection of the home, so you leave knowing about anything else worth planning for. You get the repair price before any work starts, and nothing is done without your approval.

Fans and lighting

A ceiling fan where there was only a light, a brighter fixture over the kitchen table, recessed lights in a family room: these are planned jobs with a free estimate. A fan needs a box rated to carry it, and we wire it so the fan and the light each do what you expect. See lighting installation.

Growing towns also mean a lot of home sales, and buyers in Collinsville sometimes get an inspection report that ends with a note to have the electrical evaluated. We check what the inspector flagged, tell you what is a real hazard and what is minor, and price the repairs so you can plan or negotiate.

For a small city at the edge of our area, the honest promise is simple: an arrival window you can plan around, a licensed journeyman who explains what he finds, and a price you approve before he starts. If we cannot reach you as fast as a problem needs, we will tell you on the phone rather than leave you waiting.

Calls left outside business hours are returned the next business morning, Monday to Friday.

Price and hours

Planned work gets a free estimate; troubleshooting carries a diagnostic fee with a roughly 20-point safety inspection included. You approve the price before any work starts. Hours are Monday to Friday, 8:00 AM to 4:30 PM. Send a request with your address and service, or call.